The 679 domestic wells on file within 5 miles of Jamestown, from the state’s drilling logs: your neighbors’ wells, and the best guide to this ground.
Source: PaGWIS (PA DCNR), domestic wells within 5 miles, retrieved 2026-09-30; older paper-record locations are approximate.
Bedrock Close to the Surface Near Jamestown
Bedrock is seldom far down here. The 356 logs within 5 miles that note it put rock at a median 18 feet, and a quarter found it at 12 or less. Under the town, the mapped rock is the Late Devonian Berea Sandstone through Venango Formation, a sequence of shale, sandstone and siltstone.
For a new well, that usually leaves only a thin layer of loose ground for the casing to cross before it reaches rock, and the rest of the hole is open rock. Depth sits mid-county: by median, Jamestown ranks 9th of 15 Mercer County towns, and a quarter of the logged wells reached 120 feet or more. Short casing and moderate depth both bear on the cost of drilling a new well, and drilling a home well covers how the hole is finished.
Yields Vary Widely Around Jamestown
Yield is the less predictable number. Its median across 608 logs is 20 gallons a minute, but the middle half stretches from 12 to 37, so the flow from one lot to the next is hard to call in advance. That is why the pump is chosen after the flow test, not before, and why a neighbor’s pump size is a poor guide to yours.
A well near the low end gets a smaller submersible and more tank capacity to cover heavy use; one near the high end can carry a larger pump or a constant-pressure setup. The borough’s own supply is groundwater as well, from three wells, and the authority sends its own water report to homes on the line. Water treatment in Jamestown covers what that system does.